FLANGED
IMMERSION HEATERS

Indeeco flanged immersion heaters are one of the most widely used solutions for heating fluids and gases.  Designed for use in tanks, pressure vessels, and in-line heating, flange heaters are easy to install and maintain.

SCREW PLUG
IMMERSION HEATERS

Screw plug immersion heaters are ideal for use in direct heating of liquids and gases in a variety of processes for hazardous and non-hazardous locations.  Indeeco offers customized wattages with voltages up to 600V and are available in 1", 1 ¼", 2", 2 ½" and 3" NPT sizes.

TANK HEATERS

Indeeco tank heaters are used to maintain or raise the temperature of gases and fluids in tanks from -300°F to 1000°F for a variety of applications and industries.  These heaters are designed with low watt density, open coil heating elements for uniform heating of even the most temperature sensitive materials.

RECTANGULAR FLANGE HEATERS

Large diameter elements provide extra electrical insulation for superior dielectric strength.  Element insulation is compacted to insure uniform heat transfer from coil to sheath and fall bends are repressed to insure insulation integrity in this critical area.  Special sheath materials and alternate flange designs are available for special needs.

OVER-THE-SIDE HEATERS

Indeeco over-the-side heaters are designed to provide the maximum in application flexibilty and to minimize installation costs.  They are ideal for jobs where easy installation and quick replacement or cleaning must be accomplished without emptying the tank.

BOTTOM-MOUNTED IMMERSION HEATERS

Bottom-mounted immersion heaters were originally designed for use in coffee urns.  However, their compact construction makes them ideal for use in steam tables, humidifiers, sterilizers and other applications requiring a very low heater profile and a short element length.

REPLACEMENT BOILER FLANGE HEATERS

These 4-7/8" flange heaters are three-element modules specifically designed for large steam or hot water boilers.  They offer a simple, practical solution to two problems inherent in all electrical boiler designs: element stocking and field replacement.